Examples To display all tunnels from a WSS to other switches in the Mobility Domain, type the following
command.
WSS
# show tunnel
VLAN
Local Address Remote Address State
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng
192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 15
describes the fields in the display.
Field
VLAN
Local Address
Remote Address
State
Port
LVID
RVID
See Also
show vlan config on page 89
show vlan config
Displays VLAN information.
Syntax
show vlan config [vlan-id]
vlan-id
Defaults None.
Access All.
Examples The following command displays information for VLAN burgundy:
Table 5: Output for show tunnel
Description
VLAN name.
IP address of the local end of the tunnel. This is the system IP address of
the WSS where you enter the command.
IP address of the remote end of the tunnel. This is the system IP address of
another WSS in the mobility domain.
Tunnel state:
• Up
• Dormant
Tunnel port ID.
Local VLAN ID.
Remote VLAN ID.
VLAN name or number. If you do not specify a VLAN, information for
all VLANs is displayed.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Port LVID RVID
VLAN Commands 99