Nortel 2300 Series Reference page 598

598 Boot Prompt Commands
Usage If you use an optional parameter, the parameter setting overrides the setting of the same parameter in
the currently active boot profile. However, the boot profile itself is not changed. To display the currently active
boot profile, use the show command. To change the currently active boot profile, use the change command.
Examples The following command loads system image file WSS010101.020 from boot partition 1:
boot> boot FN=WSS010101.020 DEV=boot1
Compact Flash load from boot1:testcfg matches WSS010101.020.
unzip: Inflating ramdisk_1.1.1.. OK
unzip file len 36085486 OK
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Power Cycle Reboot
Detecting hardware...done.
readclock: 2003-10-8 2:9:50.67 UTC=>1065578990.670000 (1064992894)
init: Creating mfs /dev
erase ^H, werase ^W, kill ^U, intr ^C, status ^T
Doing Nortel mounts and links
Starting nos_mon...
nos_mon:ps: not found
SYSLOGD Oct 08 02:10:05.477814 CRITICAL SYSTEM_READY: The system has finished
booting.
Copyright (c) 2002, 2003
Nortel, Inc.
Username:
Password:
See Also
• change on page 588
• show on page 596
change
Changes parameters in the currently active boot profile. (For information about boot profiles, see show on page 596.)
Syntax
change
Defaults The default boot type is c (compact flash). The default filename is default. The default flags
setting is 0x00000000 (all flags disabled) and the default options list is run=nos;boot=0. The default device
setting is the boot partition specified by the most recent set boot partition command typed at the Enabled
level of the CLI, or boot 0 if the command has never been typed.
NN47250-100 (Version 02.51)