Configuration Commands - Nortel 2350 Installation And Basic Configuration Manual

Configuration Commands

Table 12 lists the CLI commands for configuring the parameters from
syntax has been simplified to show only the options related to a typical 2350 deployment. You can use the show
commands listed in the table to verify the configuration changes.
For complete usage and syntax information about a command, see the following:
• Nortel WLAN 2300 System Software Configuration Guide
• Nortel WLAN 2300 System Software Command Reference
Configuration
Parameters
1. Enable password
2. Administrator
username and password
3. CLI management access
WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide
Table 12: Configuration Parameter List
CLI Commands
set enablepass
a Press Enter to display a username prompt.
Username:
b Press Enter again to display a password prompt.
Username:
Password:
c Press Enter a third time to display a command prompt.
Username:
Password:
2350>
d Type the enable command and press Enter once more to
display the prompt for the enabled access level.
Username:
Password:
2350> enable
2350#
e At the enabled prompt, enter set enablepass.
set user username password string
show aaa
crypto generate key ssh {1024 | 2048}
set ip telnet server enable
Note: By default, SSH is enabled and Telnet is disabled. Although
SSH is enabled by default, you cannot use it until you generate an
encryption key pair.
Configuring a 2350 Switch for a Branch Office 137
Table 11 on page 131. In some cases, command