Set Mobility-Domain Member - Nortel 2300 Series Reference

Syntax
set domain security {none | required}
none
required
Defaults The default is none. (
Access Enabled.
History Introduced in WSS Software 5.0.
Usage The setting must be the same (none or required) on all switches, the seed and all members, in the
Mobility Domain.
The set domain security none command is equivalent to the clear domain security command.
Examples The following command enables
WSS# set domain security required
success: change accepted.

set mobility-domain member

On the seed WSS, adds a member to the list of Mobility Domain members. If the current WSS is not configured as a
seed, this command is rejected.
Syntax
set mobility-domain member ip-addr key hex-bytes
ip-addr
key hex-bytes
Defaults None.
Access Enabled.
History
Version 5.0
Usage This command must be entered from the seed WSS.
Examples The following commands add three WSSs with the IP addresses 192.168.1.8, 192.168.1.9, and
192.168.1.10 as members of a Mobility Domain whose seed is the current WSS:
WSS# set mobility-domain member 192.168.1.8
success: change accepted.
WSS# set mobility-domain member 192.168.1.9
WSS WSS
- security is disabled.
WSS WSS
- security is enabled.
WSS WSS
- security is disabled.)
WSS
IP address of the Mobility Domain member in dotted decimal notation.
Fingerprint of the public key to use for
key as 16 hexadecimal bytes. Use a colon between each byte, as in the
following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff
Option key hex-bytes added.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Mobility Domain Commands 229
WSS
- security on a WSS:
WSS WSS
- security. Specify the