Show Ap Global - Nortel 2300 Series Reference

show ap global

Displays connection information for APs configured on a WSS.
Syntax
show ap global [ap-num | serial-id serial-ID]
ap-num
serial-id serial-ID
Defaults None.
Access Enabled.
Usage Connections are shown only for the APs that are configured on the WSS from which you enter the
command, and only for the Mobility Domain the switch is in.
To show information only for APs that have active connections, use the show ap connection command.
Examples The following command displays connection information for all the APs configured on a WSS:
WSS# show ap global
Total number of entries: 8
AP Serial Id
--- ----------- ----------------------
1 11223344
- 11223344
2 332211
- 332211
17 0322100185 10.3.8.111
- 0322100185 10.4.3.2
18 0321500120 10.3.8.111
- 0321500120 10.4.3.2
Table 53 describes the fields in this display.
Field
AP
Serial Id
Number of a AP for which to display configuration settings.
AP serial ID.
WSS IP Address Bias
----
10.3.8.111 HIGH
10.4.3.2 LOW
10.3.8.111 LOW
10.4.3.2 HIGH
HIGH
LOW
LOW
HIGH
Table 20: Output for show ap global
Description
Connection ID you assigned to the AP.
Note: AP numbers are listed only for APs configured on this
WSS. If the field contains a hyphen ( - ), the AP configuration
displayed in the row of output is on another WSS.
Serial ID of the AP.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 383