Show Ap Status - Nortel 2300 Series Reference

368 AP Commands
TX: 307 44279
RX: 315 215046
Table 45 on page 358
Field
AP
Name
IP-addrs
Operational Mode
Downlink Mesh-APs
BSSID
TX
RX
See Also
• set ap boot-configuration mesh ssid on page 254
• set service-profile mesh on page 320

show ap status

Displays AP and radio status information.
Syntax
show ap status [terse] | [port-list | all [radio {1 | 2}]]
terse
port-list
ap-num
all
NN47250-100 (Version 02.51)
describes the fields in the show ap mesh-links output.
Table 12: Output for show ap mesh-links
Description
Identifier for the AP on the WSS.
V-LAN name.
IP address of AP.
Indicates whether the AP is a Mesh AP or
Mesh Portal AP.
Information about the Mesh APs that are
associated with the Mesh Portal AP.
Indicates the BSSID of the Mesh AP.
Indicates the amount of traffic (packets and
bytes) transmitted to the Mesh AP.
Indicates the amount of traffic (packets and
bytes) transmited to the Mesh AP.
Displays a brief line of essential status information for each AP.
List of ports connected to the AP(s) for which to display status.
Number of a AP for which to display status.
Shows status information for all directly attached APs and all APs
configured on the switch.