494 RADIUS and Server Groups Commands
retransmit
timeout
Defaults Global RADIUS parameters have the following default values:
•
deadtime—0 (zero) minutes (The WSS does not designate unresponsive RADIUS servers as unavailable.)
•
key—No key
•
retransmit—3 (the total number of attempts, including the first attempt)
•
timeout—5 seconds
Access Enabled.
History Introduced in WSS Software 1.0.
Usage To override the globally set values on a particular RADIUS server, use the set radius server
command.
Examples To reset all global RADIUS parameters to their factory defaults, type the following commands:
WSS# clear radius deadtime
success: change accepted.
WSS# clear radius key
success: change accepted.
WSS# clear radius retransmit
success: change accepted.
WSS# clear radius timeout
success: change accepted.
See Also
•
set radius on page 487
•
set radius server on page 490
•
show aaa on page 210
clear radius client system-ip
Removes the WSS's system IP address from use as the permanent source address in RADIUS client requests from the
switch to its RADIUS server(s).
Syntax
clear radius client system-ip
Defaults None.
Access Enabled.
History Introduced in WSS Software 1.0.
Usage The clear radius client system-ip command causes the WSS to use the IP address of the interface
through which it sends a RADIUS client request as the source IP address. The WSS selects a source interface
address based on information in its routing table as the source address for RADIUS packets leaving the switch.
NN47250-100 (Version 02.51)
Number of transmission attempts made before declaring an unresponsive
RADIUS server unavailable.
Number of seconds to wait for the RADIUS server to respond before
retransmitting.