Set Ap Fingerprint; Set Ap Force-Image-Download - Nortel 2300 Series Reference

set ap fingerprint

Verifies an AP's fingerprint on a WSS. If AP-WSS security is required by a WSS, an AP can establish a management
session with the switch only if you have verified the AP's identity by verifying its fingerprint on the switch.
Syntax
set ap num fingerprint hex
ap ap-num
hex
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.0.
Option dap removed in 6.0.
Usage APs are configured with an encryption key pair at the factory. The fingerprint for the public key is
displayed on a label on the back of the AP, in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
If an AP is already installed and operating, you can use the show ap status command to display the fingerprint. The
show ap config command lists an AP's fingerprint only if the fingerprint has been verified in WSS Software. If the
fingerprint has not been verified, the fingerprint information in the command output is blank.
Examples The following example verifies the fingerprint for AP 8:
WSS# set ap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
success: change accepted.
See Also
• set ap security on page 274
• show ap config on page 344
• show ap status on page 358

set ap force-image-download

Configures an AP to download its software image from the WSS instead of loading the image that is locally stored on the
AP.
Syntax
set {ap port-list | ap {ap-num | auto}} force-image-download {enable | disable}
ap port-list
ap ap-num
Number of the AP whose fingerprint you are verifying.
The 16-digit hexadecimal number of the fingerprint. Use a colon between
each digit. Make sure the fingerprint you enter matches the fingerprint
used by the AP.
List of AP access ports.
Number of a AP.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 267