Logout
The Logout command (accessed from the main menu) allows a user working at a
password-protected console terminal or in an active TELNET session to terminate
the session.
The Logout command works as follows:
•
•
BayStack Model 350T HW:Rev x
Figure 3-39.
You can specify whether a password is required for the TELNET session or the
console terminal using the Console/Service Port Configuration screen (see
"Console/Service Port
If the console terminal is not password protected, the system ignores the Logout
command.
893-00992-E
If you are accessing the BayStack 350 switch through a TELNET session, the
Logout command terminates the TELNET session.
If you are accessing the BayStack 350 switch through a password-protected
console terminal (connected to the console/service port on the switch), the
Logout command displays the console-terminal password prompt
(Figure
3-39). You must enter the correct password to access the CI.
Password:
Enter Password:
Password prompt screen
Configuration" on
FW:V x.xx SW:V x.x.x
[ *************** ]
page
3-58).
Using the Console Interface
3-83