Set Port Speed - Nortel 2300 Series Reference
Wlan security switch command line reference
Hide thumbs
Also See for 2300 Series:
- Configuration manual (658 pages) ,
- Solution manual (108 pages) ,
- Installation and configuration manual (66 pages)
Table of Contents
Advertisement
50 Port Commands
Defaults PoE is disabled on network and wired authentication ports. The state on AP ports
depends on whether you enabled or disabled PoE when setting the port type. See set port type ap on
page 41.
Access Enabled.
Usage This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the 2360
and 2382 switch.
Examples The following command disables PoE on ports 7 and 9, which are connected to an AP:
WSS# set port poe 7,9 disable
If you are enabling power on these ports, they must be connected only to approved PoE
devices with the correct wiring. Do you wish to continue? (y/n) [n]y
The following command enables PoE on ports 7 and 9:
WSS# set port poe 7,9 enable
If you are enabling power on these ports, they must be connected only to approved PoE
devices with the correct wiring. Do you wish to continue? (y/n) [n]y
See Also
•
set port type ap on page 41
•
set port type wired-auth on page 44
set port speed
Changes the speed of a port.
Syntax
set port speed port-list {10 | 100 | 1000 | auto}
port-list
10
100
1000
auto
Defaults All ports are set to auto.
Access Enabled.
Usage Nortel recommends that you do not configure the mode of a WSS port so that one side of
the link is set to autonegotiation while the other side is set to full-duplex. Although WSS Software
allows this configuration, it can result in slow throughput on the link. The slow throughput occurs
because the side that is configured for autonegotiation falls back to half-duplex. A stream of large
NN47250-100 (Version 02.51)
List of physical ports. WSS Software sets the port speed on all the
specified ports.
Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the
operating mode to full-duplex.
Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the
operating mode to full-duplex.
Sets the port speed of a gigabit Ethernet port to 1000 Mbps and sets the
operating mode to full-duplex.
Enables a port to detect the speed and operating mode of the traffic on the
link and set itself accordingly.
Advertisement
Table of Contents
