Set Spantree; Set Spantree Backbonefast - Nortel 2300 Series Reference

See Also
show spantree statistics on page 407

set spantree

Enables or disables STP on one VLAN or all VLANs configured on a WSS.
Syntax
set spantree {enable | disable}
[{all | vlan vlan-id | port port-list vlan-id}]
enable
disable
all
vlan vlan-id
port port-list vlan-id
Defaults Disabled.
Access Enabled.
Examples The following command enables STP on all VLANs configured on a WSS:
WSS# set spantree enable
success: change accepted.
The following command disables STP on VLAN burgundy:
WSS# set spantree disable vlan burgundy
success: change accepted.
See Also
show spantree on page 400

set spantree backbonefast

Enables or disables STP backbone fast convergence on a WSS. This feature accelerates a port's recovery following the
failure of an indirect link.
Syntax
set spantree backbonefast {enable | disable}
enable
disable
Defaults STP backbone fast path convergence is disabled by default.
Access Enabled.
Enables STP.
Disables STP.
Enables or disables STP on all VLANs.
VLAN name or number. WSS Software enables or disables STP on only
the specified VLAN, on all ports within the VLAN.
Port number or list and the VLAN the ports are in. WSS Software enables
or disables STP on only the specified ports, within the specified VLAN.
Enables backbone fast convergence.
Disables backbone fast convergence.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
STP Commands 403