Clear Ap Boot-Configuration; Clear Ap Radio Load-Balancing Group - Nortel 2300 Series Reference

clear ap boot-configuration

Removes the static IP address configuration for a AP.
Syntax
clear ap boot-configuration ap-num
ap ap-num
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.1.
Option dap removed in 6.0.
Usage When the static IP configuration is cleared for a AP, the next time the AP is rebooted, it uses the
standard boot process.
Examples The following command clears the static IP address configuration for AP 1.
WSS# clear ap 1 boot-configuration
This will clear specified AP devices. Would you like to continue? (y/n) [n]y
success: static info cleared.
• set ap boot-configuration ip on page 251
• set ap boot-configuration switch on page 255
• set ap boot-configuration vlan on page 256
• show ap boot-configuration on page 370

clear ap radio load-balancing group

Removes an AP radio from its load-balancing group.
Syntax
clear ap ap-number radio {1 | 2} load-balancing group
ap ap-number
radio 1
radio 2
Defaults None.
Access Enabled.
History Introduced in WSS Version 6.0.
Usage If an AP radio has been assigned to an RF load balancing group, you can use this command to
remove the AP radio from the group.
Number of the AP for which you are clearing static IP information.
Index value that identifies the AP on the WSS.
Radio 1 of the AP.
Radio 2 of the AP. (This option does not apply to single-radio models.)
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 251