132 IP Services Commands
set ntp server
Configures a WSS to use an NTP server.
Syntax
set ntp server ip-addr
ip-addr
Defaults None.
Access Enabled.
Usage You can configure up to three NTP servers. WSS Software queries all the servers and
selects the best response based on the method described in RFC 1305, Network Time Protocol
(Version 3) Specification, Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp command.
Examples The following command configures a WSS to use NTP server 192.168.1.5:
WSS# set ntp server 192.168.1.5
See Also
•
clear ntp server on page 102
•
clear ntp update-interval on page 103
•
set ntp on page 121
•
set ntp update-interval on page 122
•
show ntp on page 156
set ntp update-interval
Changes how often WSS Software sends queries to the NTP servers for updates.
Syntax
set ntp update-interval seconds
seconds
Defaults The default NTP update interval is 64 seconds.
Access Enabled.
Examples The following command changes the NTP update interval to 128 seconds:
WSS# set ntp update-interval 128
success: change accepted.
NN47250-100 (Version 02.51)
IP address of the NTP server, in dotted decimal notation.
Number of seconds between queries. You can specify from 16 through 1024
seconds.