Nortel 2300 Series Reference page 100

100 VLAN Commands
WSS# show vlan config burgundy
VLAN Name Status
---- ---------------- ------ ----- ----- ---------------- ----- ------------------
2 burgundy
Table 16 describes the fields in this display.
Field
VLAN
Name
Admin Status
VLAN State
Tunl Affin
Port
Tag
Port State
NN47250-100 (Version 02.51)
Admin VLAN
State
Up Up
2
3
4
6
11
t:10.10.40.4 none
Table 6: Output for show vlan config
Description
VLAN number.
VLAN name.
Administrative status of the VLAN:
• Down—The VLAN is disabled.
• Up—The VLAN is enabled.
Link status of the VLAN:
• Down—The VLAN is not connected.
• Up—The VLAN is connected.
Tunnel affinity value assigned to the VLAN.
Member port of the VLAN. The port can be a physical port or a
virtual port.
• Physical ports are 10/100 Ethernet or gigabit
Ethernet ports on the switch, and are listed by port
number.
• Virtual ports are tunnels to other switches in a
mobility domain, and are listed as follows: t:ip-
addr, where ip-addr is the system IP address of
the WSS at the other end of the tunnel.
Note: This field can include AP access ports and wired
authentication ports, because WSS Software dynamically adds
these ports to a VLAN when handling user traffic for the VLAN.
Tag value assigned to the port.
Link state of the port:
• Down—The port is not connected.
• Up—The port is connected.
Tunl Port
Affin Port Tag State
5
none Up
none Up
none Up
none Up
none Up
Up