Defaults IP interfaces are enabled by default.
Access Enabled.
Examples The following command disables the IP interface on VLAN mauve:
WSS# set interface mauve status down
success: set interface mauve to down
See Also
•
clear interface on page 99
•
set interface on page 109
•
show interface on page 149
set ip alias
Configures an alias, which maps a name to an IP address. You can use aliases as shortcuts in CLI commands.
Syntax
set ip alias name ip-addr
name
ip-addr
Defaults None.
Access Enabled.
Examples The following command configures the alias HR1 for IP address 192.168.1.2:
WSS# set ip alias HR1 192.168.1.2
success: change accepted.
See Also
•
clear ip alias on page 100
•
show ip alias on page 150
set ip dns
Enables or disables DNS on a WSS.
Syntax
set ip dns {enable | disable}
enable
disable
Defaults DNS is disabled by default.
String of up to 32 alphanumeric characters, with no spaces.
IP address in dotted decimal notation.
Enables DNS.
Disables DNS.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
IP Services Commands 123