580 Snoop Commands
Defaults Snoop filters are disabled by default.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Usage The filter mode is not retained if you change the filter configuration or disable and
reenable the radio, or when the AP or the WSS is restarted. You must reenable the filter to place it
back into effect.
Examples The following command enables snoop filter snoop1, and configures the filter to stop
after 5000 packets match the filter:
WSS# set snoop snoop1 mode enable stop-after 5000
success: filter 'snoop1' enabled
See Also
•
show snoop on page 570
•
show snoop info on page 571
•
show snoop map on page 571
•
show snoop stats on page 572
show snoop
Displays the AP radio mapping for all snoop filters.
Syntax
show snoop
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.0.
Usage To display the mappings for a specific AP radio, use the show snoop map command.
Examples The following command shows the AP radio mappings for all snoop filters configured
on a WSS:
WSS# show snoop
ap: 3
Radio: 2
snoop1
snoop2
ap: 2
Radio: 2
snoop2
See Also
•
clear snoop map on page 566
•
set snoop map on page 568
•
show snoop map on page 571
NN47250-100 (Version 02.51)