Set Service-Profile Tkip-Mc-Time - Nortel 2300 Series Reference

any ACLs that mark CoS. This option provides a simple way to configure an SSID for priority traffic such as VoIP
traffic.
When static CoS is enabled, the standard WSS Software prioritization mechanism is not used. Instead, the AP sets CoS
as follows:
• For traffic from the AP to clients, the AP places the traffic into the forwarding queue that corresponds to the CoS
level configured on the service profile. For example, if the static CoS level is set to 7, the AP radio places client
traffic in its Voice queue.
• For traffic from clients to the network, the AP marks the DSCP value in the IP headers of the tunnel packets used to
carry the user data from the AP to the WSS.
Syntax
set service-profile name static-cos {enable | disable}
name
enable
disable
Defaults Static CoS is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage The CoS level is specified by the set service-profile cos command.
Examples The following command enables static CoS on service profile sp1:
WSS# set service-profile sp1 static-cos enable
success: change accepted.
See Also
• set service-profile cos on page 315
• show service-profile on page 380

set service-profile tkip-mc-time

Changes the length of time that AP radios use countermeasures if two message integrity code (MIC) failures occur
within 60 seconds. When countermeasures are in effect, AP radios dissociate all TKIP and WPA WEP clients and refuse
all association and reassociation requests until the countermeasures end.
Syntax
set service-profile name tkip-mc-time wait-time
name
wait-time
Defaults The default countermeasures wait time is 60,000 ms (60 seconds).
Access Enabled.
Service profile name.
Enables static CoS on the service profile.
Disables static CoS on the service profile.
Service profile name.
Number of milliseconds (ms) countermeasures remain in effect. You can
specify from 0 to 60,000.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 343