262 AP Commands
•
show ap boot-configuration on page 370
set ap boot-configuration mesh mode
Enables WLAN mesh services on the AP.
Syntax
set ap ap-number boot-configuration mesh mode {enable | disable}
ap ap-number
mode {enable | disable}
Defaults Disabled.
Access Enabled.
History Introduced in WSS Version 6.0.
Usage Use this command to enable WLAN mesh services for an Mesh AP. Prior to deploying the Mesh AP
in its final untethered location, you must connect the AP to an WSS switch and enter this command to
configure the AP for mesh services.
Examples The following command enables WLAN mesh services for AP 7:
WSS# set ap 7 boot-configuration mesh mode enable
success: change accepted.
See Also
•
set ap boot-configuration mesh ssid on page 254
•
set service-profile mesh on page 320
•
show ap mesh-links on page 357
set ap boot-configuration mesh psk-phrase
Specifies a preshared key (PSK) phrase that a Mesh AP uses for authentication to its Mesh Portal AP.
Syntax
set ap ap-number boot-configuration mesh psk-phrase passphrase
ap ap-number
passphrase
Defaults None.
Access Enabled.
History Introduced in WSS Version 6.0.
NN47250-100 (Version 02.51)
Index value that identifies the AP on the WSS.
Enables or disables WLAN mesh services for the AP.
Index value that identifies the AP on the WSS.
An ASCII string from 8 to 63 characters long. The string can
contain blanks if you use quotation marks at the beginning
and end of the string.