Usage Before using this command, you must configure values for the WEP keys you plan to use.
Use the set service-profile wep key-index command.
Examples The following command configures service profile sp2 to use WEP key 2 for
encrypting multicast traffic:
WSS# set service-profile sp2 wep active-multicast-index 2
success: change accepted.
See Also
•
set service-profile wep active-unicast-index on page 341
•
set service-profile wep key-index on page 342
•
show service-profile on page 380
set service-profile wep active-unicast-index
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting unicast frames.
Syntax
set service-profile name wep active-unicast-index num
name
num
Defaults If WEP encryption is enabled and WEP keys are defined, AP radios use WEP key 1 to
encrypt unicast frames, by default.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage Before using this command, you must configure values for the WEP keys you plan to use.
Use the set service-profile wep key-index command.
Examples The following command configures service profile sp2 to use WEP key 4 for
encrypting unicast traffic:
WSS# set service-profile sp2 wep active-unicast-index 4
success: change accepted.
See Also
•
set service-profile wep active-multicast-index on page 340
•
set service-profile wep key-index on page 342
•
show service-profile on page 380
Service profile name.
WEP key number. You can enter a value from 1 through 4.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 351