Nortel 2300 Series Reference page 142

142 IP Services Commands
retries num
timeout num
SNMPv3 with Traps
To configure a notification target for traps from SNMPv3, use the following command:
Syntax
set snmp notify target target-num ip-addr[:udp-port-number]
usm trap user username
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
target-num
ip-addr[:udp-port-number]
username
profile profile-name
security {unsecured | authenticated |
encrypted}
NN47250-100 (Version 02.51)
Specifies the number of times the WSS Software
SNMP engine will resend a notification that has not
been acknowledged by the target. You can specify
from 0 to 3 retries.
Specifies the number of seconds WSS Software waits
for acknowledgement of a notification. You can
specify from 1 to 5 seconds.
ID for the target. This ID is local to the WSS and does
not need to correspond to a value on the target itself.
You can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP
port number to send notifications to.
USM username. This option is applicable only when
the SNMP version is usm.
Notification profile this SNMP user will use to specify
the notification types to send or drop.
Specifies the security level, and is applicable only
when the SNMP version is usm:
• unsecured—Message exchanges are not
authenticated, nor are they encrypted.
This is the default.
• authenticated—Message exchanges are
authenticated, but are not encrypted.
• encrypted—Message exchanges are
authenticated and encrypted.