Syntax
set mobility-domain mode member secondary-seed-ip secondary-seed-ip-addr
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 6.0.
Examples Following is the example of mobility-domain secondary-seed-ip.
WSS# set mobility-domain mode member secondary-seed-ip 192.168.1.8
Success: change accepted
set mobility-domain mode seed domain-name
Creates a Mobility Domain by setting the current WSS as the seed device and naming the Mobility Domain.
Syntax
set mobility-domain mode seed domain-name mob-domain-name
mob-domain-name
Defaults None.
Access Enabled.
History
Version 4.1
Usage Before you use this command, the current WSS must have its IP address set with the set system ip-
address command. After you enter this command, all Mobility Domain traffic is sent and received from the
specified IP address.
You must explicitly configure only one WSS per domain as the seed. All other WSSs in the domain receive their
Mobility Domain information from the seed.
Examples The following command creates a Mobility Domain named Santa Clara with the current WSS as
the seed:
WSS# set mobility-domain mode seed domain-name Santa Clara
mode is: seed
domain name is: Santa Clara
See Also
•
clear mobility-domain member on page 218
•
show mobility-domain on page 222
Name of the Mobility Domain. Specify between 1 and 32 characters with
no spaces.
Maximum length of mob-domain-name increased to 32
characters.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Mobility Domain Commands 231