Nortel 2300 Series Reference page 356

Wlan security switch command line reference

Hide thumbs Also See for 2300 Series:

Table of Contents

356 AP Commands

boot-download-enable

force-image-download

load balancing group

NN47250-100 (Version 02.51)

Table 7: Output for show ap config

WSS port number.

Note: This field is applicable only if the AP is directly connected

to the WSS and the WSS's port is configured as an AP access

Connection ID for the AP.

Note: This field is applicable only if the AP is configured on the

WSS as a AP.

Serial ID of the AP.

Note: This field is displayed only for APs.

AP model number.

PoE state on the WSS port:

Hexadecimal fingerprint of the AP's public encryption key.

Note: This field is displayed only for APs. If the field is blank,

the key has not been verified yet by an administrator. (See set ap

fingerprint on page 257.)

State of the firmware upgrade option:

• YES (automatic upgrades are enabled)

• NO (automatic upgrades are disabled)

State of the option to force the AP to o

Names of the AP load-balancing groups to which the AP

belongs. If the value is None, the access point does not belong to

any load balancing groups.

Note: This field is displayed only if the AP is a member of a

Radio number. The information listed below this field applies

specifically to the radio.

connection to the AP: