Show Tunnel - Nortel 2300 Series Reference

98 VLAN Commands
Examples The following command shows Layer 2 forwarding restriction information for all
VLANs:
WSS# show security l2-restrict
VLAN Name
---- ---------------- -- ---------- ------------------- ---------------------
1 default
2 vlan-2
Table 14 describes the fields in the display.
Table 4: Output for show security l2-restrict
Field
VLAN
Name
En
Drops
Permit MAC
Hits
See Also
• clear security l2-restrict on page 75
• clear security l2-restrict counters on page 75
• set security l2-restrict on page 78

show tunnel

Displays the tunnels from the WSS where you type the command.
Syntax
show tunnel
Defaults None.
Access Enabled
NN47250-100 (Version 02.51)
En Drops Permit MAC
Y 0 00:0b:0e:02:53:3e
00:30:b6:3e:5c:a8
Y 0 04:04:04:04:04:04
Description
VLAN number.
VLAN name.
Enabled state of the feature for the VLAN:
• Y—Enabled. Forwarding of Layer 2 traffic from clients is
restricted to the MAC address(es) listed under Permit
MAC.
• N—Disabled. Layer 2 forwarding is not restricted.
Number of packets dropped because the destination MAC address was not
one of the addresses listed under Permit MAC.
MAC addresses to which clients in the VLAN are allowed to send traffic at
Layer 2.
Number of packets whose source MAC address was a client in this VLAN,
and whose destination MAC address was one of those listed under Permit
MAC.
Hits
5947
9
0