266 AP Commands
See Also
•
clear ap boot-configuration on page 241
•
set ap boot-configuration ip on page 251
•
set ap boot-configuration vlan on page 256
•
show ap boot-configuration on page 370
set ap boot-configuration vlan
Specifies 802.1Q VLAN tagging information for a AP.
Syntax
set ap ap-num boot-configuration vlan vlan-tag tag-value [mode {enable |
disable}]
Syntax
set ap ap-num boot-configuration vlan mode {enable | disable}
ap ap-num
vlan-tag tag-value
mode {enable | disable}
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.1.
Option dap removed.
Usage When this command is configured, all Ethernet frames emitted from the AP are formatted
with an 802.1Q tag with a specified VLAN number. Frames sent to the AP that are not tagged with
this value are ignored.
Examples The following command configures AP 1 to use VLAN tag 100:
WSS# set ap 1 boot-configuration vlan vlan-tag 100 mode enable
success: change accepted.
See Also
•
clear ap boot-configuration on page 241
•
set ap boot-configuration ip on page 251
•
set ap boot-configuration switch on page 255
•
show ap boot-configuration on page 370
NN47250-100 (Version 02.51)
Number of the AP for which you are specifying VLAN
information.
The VLAN tag value. You can specify a number from 1 –
4095.
Enables or disables use of the specified VLAN tag on the AP.