Set Mobility-Domain Mode Member Seed-Ip - Nortel 2300 Series Reference

230 Mobility Domain Commands
success: change accepted.
WSS# set mobility-domain member 192.168.1.10
success: change accepted.
See Also
• clear mobility-domain member on page 218
• show mobility-domain config on page 222

set mobility-domain mode member seed-ip

On a nonseed WSS, sets the IP address of the seed WSS. This command is used on a member
member. If the WSS is currently part of another Mobility Domain or using another seed, this command overwrites that
configuration.
Syntax
set mobility-domain mode member seed-ip ip-addr key hex-bytes
ip-addr
key hex-bytes
Defaults None.
Access Enabled.
History
Version 5.0
Examples The following command sets the current WSS as a nonseed member of the Mobility Domain
whose seed has the IP address 192.168.1.8:
WSS# set mobility-domain mode member seed-ip 192.168.1.8
mode is: member
seed IP is: 192.168.1.8
See Also
• clear mobility-domain on page 218
• show mobility-domain config on page 222
set mobility-domain mode member secondary-seed-
ip
This command is used on a member
NN47250-100 (Version 02.51)
IP address of the Mobility Domain member, in dotted decimal notation.
Fingerprint of the public key to use for
key as 16 hexadecimal bytes. Use a colon between each byte, as in the
following example:
00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff
Option key hex-bytes added.
WSS
to configure it as a member of secondary seed.
WSS
WSS WSS
- security. Specify the
to configure it as a