Set Log Mark - Nortel 2300 Series Reference

588 System Log Commands
Usage Using the command with only enable or disable turns logging on or off for the target at all levels.
For example, entering set log buffer enable with no other keywords turns on logging to the system buffer of
all facilities at all levels. Entering set log buffer disable with no other keywords turns off all logging to the
buffer.
Examples To log only emergency, alert, and critical system events to the console, type the following
command:
WSS# set log console severity critical enable
success: change accepted.
See Also
• show log config on page 581
• clear log on page 575

set log mark

Configures WSS Software to generate mark messages at regular intervals. The mark messages indicate the current
system time and date. Nortel can use the mark messages to determine the approximate time when a system restart or
other event causing a system outage occurred.
Syntax
set log mark [enable | disable] [severity level]
[interval interval]
enable
disable
severity level
interval interval
Defaults Mark messages are disabled by default. When they are enabled, WSS Software generates a
message at the notice level once every 300 seconds by default.
Access Enabled.
History Introduced in WSS Software Version 4.1.
NN47250-100 (Version 02.51)
Enables the mark messages.
Disables the mark messages.
Log severity at which the messages are logged:
• emergency
• alert
• critical
• error
• warning
• notice
• info
• debug
Interval at which WSS Software generates the mark messages. You
can specify from 1 to 2147483647 seconds.