Syntax
set igmp oqi seconds [vlan vlan-id]
oqi seconds
vlan vlan-id
Defaults The default other-querier-present interval is 255 seconds (4.25 minutes).
Access Enabled.
Usage A WSS cannot become the querier unless the pseudo-querier feature is enabled on the switch. When
the feature is enabled, the switch becomes the querier for a subnet so long as the switch does not receive a
query message from a router with a lower IP address than the IP address of the switch in that subnet. To enable
the pseudo-querier feature, use set igmp querier.
Examples The following command changes the other-querier-present interval on VLAN orange to 200
seconds:
WSS# set igmp oqi 200 vlan orange
success: change accepted.
See Also
•
set igmp lmqi on page 416
•
set igmp qi on page 420
•
set igmp qri on page 420
•
set igmp querier on page 421
•
set igmp mrouter on page 417
•
set igmp rv on page 422
set igmp proxy-report
Disables or reenables proxy reporting by a WSS on one VLAN or all VLANs.
Syntax
set igmp proxy-report {enable | disable} [vlan vlan-id]
enable
disable
vlan vlan-id
Defaults Proxy reporting is enabled on all VLANs by default.
Access Enabled.
Number of seconds that the WSS waits for a general query to arrive
before electing itself the querier. You can specify a value from 1 through
65,535.
VLAN name or number. If you do not specify a VLAN, the timer change
applies to all VLANs.
Enables proxy reporting.
Disables proxy reporting.
VLAN name or number. If you do not specify a VLAN, proxy reporting is
disabled or reenabled on all VLANs.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
IGMP Snooping Commands 429