Nortel 2300 Series Reference page 590

590 System Log Commands
severity severity-level
Defaults None.
Access Enabled.
History
Version 5.0
Usage The debug level produces a lot of messages, many of which can appear to be somewhat
cryptic. Debug messages are used primarily by Nortel for troubleshooting and are not intended for
administrator use.
Examples Type the following command to see the facilities for which you can view event
messages archived in the buffer:
WSS# show log buffer facility ?
<facility name>
ARP, ASO, BOOT, CLI, CLUSTER, CRYPTO, DOT1X, NET, ETHERNET,
GATEWAY, HTTPD, IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB,
ROAM, ROGUE, SM, SNMPD, SPAN, STORE, SYS, TAGMGR, TBRIDGE,
TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, RAPDA,
WEBVIEW, EAP, FP, STAT, SSHD, SUP, DNSD, CONFIG, BACKUP.
The following command displays logged messages for the AAA facility:
WSS# show log buffer facility AAA
AAA Jun. 25 09:11:32.579848 ERROR AAA_NOTIFY_ERR: AAA got SM special
event (98) on locality 3950 which is gone
NN47250-100 (Version 02.51)
Displays messages at a severity level greater than or equal to the
level specified. Specify one of the following:
• emergency—The WSS is unusable.
• alert—Action must be taken immediately.
• critical—You must resolve the critical conditions.
If the conditions are not resolved, the WSS can
reboot or shut down.
• error—The WSS is missing data or is unable to
form a connection.
• warning—A possible problem exists.
• notice—Events that potentially can cause system
problems have occurred. These are logged for
diagnostic purposes. No action is required.
• info—Informational messages only. No problem
exists.
• debug—Output from debugging.
Option COPP removed. The option is not applicable to WSS
Software Version 5.0.
Select one of: KERNEL, AAA, SYSLOGD, ACL, AP, APM,