Set Boot Partition; Set Boot Configuration-File - Nortel 2300 Series Reference

560 File Management Commands
Examples The following command specifies a file called backup.cfg as the backup configuration
file on the WSS:
WSS# set boot backup-configuration backup.cfg
success: backup boot config filename set.
See Also
• clear boot backup-configuration on page 537
• show boot on page 551

set boot configuration-file

Changes the configuration file to load after rebooting.
Syntax
set boot configuration-file filename
filename
Defaults The default configuration filename is configuration.
Access Enabled.
Usage The file must be located in the switch's nonvolatile storage.
Examples The following command sets the boot configuration file to testconfig1:
WSS# set boot configuration-file testconfig1
success: boot config set.

set boot partition

Specifies the boot partition in which to look for the system image file following the next system reset, software
reload, or power cycle.
Syntax
set boot partition {boot0 | boot1}
boot0
boot1
Defaults By default, a WSS uses the same boot partition for the next software reload that was
used to boot the currently running image.
Access Enabled.
NN47250-100 (Version 02.51)
Filename. Specify between 1 and 128 alphanumeric characters, with no
spaces.
To load the file from a subdirectory, specify the subdirectory name,
followed by a forward slash, in front of the filename. For example:
backup_configs/config_c.
Boot partition 0.
Boot partition 1.