Set Ip Snmp Server; Set Ip Ssh - Nortel 2300 Series Reference

128 IP Services Commands
• clear ip route on page 101
• show interface on page 149
• show ip route on page 153

set ip snmp server

Enables or disables the SNMP service on the WSS.
Syntax
set ip snmp server {enable | disable}
enable
disable
Defaults The SNMP service is disabled by default.
Access Enabled.
Examples The following command enables the SNMP server on a WSS:
WSS# set ip snmp server enable
success: change accepted.
See Also
• clear snmp notify target on page 104
• set port trap on page 41
• set snmp community on page 123
• set snmp notify profile on page 125

set ip ssh

Changes the TCP port number on which a WSS listens for Secure Shell (SSH) management traffic.
Caution!
immediately ends the session. To open a new management session, you must configure
the SSH client to use the new TCP port number.
Syntax
set ip ssh port port-num
port-num
Defaults The default SSH port number is 22.
Access Enabled.
NN47250-100 (Version 02.51)
Enables the SNMP service.
Disables the SNMP service.
If you change the SSH port number from an SSH session, WSS Software
TCP port number.