Nortel 2300 Series Reference page 309

Table 5: Defaults for Service Profile Parameters (continued)
Parameter
cipher-ccmp
cipher-tkip
cipher-wep104
cipher-wep40
cos
dhcp-restrict
idle-client-probing
keep-initial-vlan
long-retry-count
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Default Value
disable
enable
disable
disable
0
disable
enable
disable
5
Radio Behavior When
Parameter Set To
Default Value
Does not use Counter with Cipher
Block Chaining Message
Authentication Code Protocol
(CCMP) to encrypt traffic sent to
WPA clients.
When the WPA IE is enabled,
uses Temporal Key Integrity
Protocol (TKIP) to encrypt traffic
sent to WPA clients.
Does not use Wired Equivalent
Privacy (WEP) with 104-bit keys
to encrypt traffic sent to WPA
clients.
Does not use WEP with 40-bit
keys to encrypt traffic sent to
WPA clients.
If static CoS is enabled (static-cos
is set to enable), assigns CoS 0 to
all data traffic to or from clients.
Does not restrict a client's traffic
to only DHCP traffic while the
client is being authenticated and
authorized.
Sends a keepalive packet (a null-
data frame) to each client every
10 seconds.
Reassigns the user to a VLAN
after roaming, instead of leaving
the roamed user on the VLAN
assigned by the switch where the
user logged on.
Note: Enabling this option does
not retain the user's initial VLAN
assignment in all cases. (For
information, see "set service-
profile keep-initial-vlan" on
page 317.)
Sends a long unicast frame up to
five times without
acknowledgment.
AP Commands 309