Set Radius - Nortel 2300 Series Reference

See Also
set server group on page 492

set radius

Configures global defaults for RADIUS servers that do not explicitly set these values themselves. By default, the WSS
automatically sets all these values except the password (key).
Syntax
set radius {deadtime minutes | encrypted-key string | key string | retransmit number |
timeout seconds}
deadtime minutes
encrypted-key string
key string
retransmit number
timeout seconds
Defaults Global RADIUS parameters have the following default values:
• deadtime—0 (zero) minutes (The WSS does not designate unresponsive RADIUS servers as unavailable.)
• encrypted-key—No key
• key—No key
• retransmit—3 (the total number of attempts, including the first attempt)
• timeout—5 seconds
Access Enabled.
Number of minutes the WSS waits after declaring an
unresponsive RADIUS server unavailable before retrying the
RADIUS server. You can specify from 0 to 1440 minutes.
Password (shared secret key) used to authenticate to the RADIUS
server, entered in its encrypted form. You must provide the same
encrypted password that is defined on the RADIUS server. The
password can be 1 to 64 characters long, with no spaces or tabs.
WSS Software does not encrypt the string you enter, and instead
displays the string in show config and show aaa output exactly
as you entered it.
Note: Use this option only if you are entering the key in its
encrypted form. To enter the key in unencrypted form, use the
key string option instead.
Password (shared secret key) used to authenticate to the RADIUS
server, entered in its unencrypted form. You must provide the
same password that is defined on the RADIUS server. The
password can be 1 to 64 characters long, with no spaces or tabs.
WSS Software encrypts the displayed form of the string in show
config and show aaa output.
Note: Use this option only if you are entering the key in its
unencrypted form. To enter the key in encrypted form, use the
encrypted-key string option instead.
Number of transmission attempts the WSS makes before
declaring an unresponsive RADIUS server unavailable. You can
specify from 1 to 100 retries.
Number of seconds the WSS waits for the RADIUS server to
respond before retransmitting. You can specify from 1 to 65,535.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
RADIUS and Server Groups Commands 497