Show Qos - Nortel 2300 Series Reference

set qos dscp-to-cos-map
Changes the internal QoS value to which WSS Software maps a packet's DSCP value when classifying inbound packets.
Syntax
set qos dscp-to-cos-map dscp-range cos level
dscp-range
cos level
Defaults The defaults are listed by the show qos command.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Examples The following command maps DSCP values 40-56 to internal CoS value 6:
WSS# set qos dscp-to-cos-map 40-56 cos 6
warning: cos 5 is marked with dscp 63 which will be classified as cos 7
warning: cos 7 is marked with dscp 56 which will be classified as cos 6
As shown in this example, if the change results in a change to CoS, WSS Software displays a warning message indi-
cating the change.
See Also
• set qos cos-to-dscp-map on page 94
• show qos on page 95

show qos

Displays the switch's QoS settings.
Syntax
show qos [default]
default
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Examples The following command displays the default QoS settings:
WSS# show qos default
DSCP range. You can specify the values as decimal numbers. Valid
decimal values are 0 to 63.
To specify a range, use the following format: 40-56. Specify the
lower number first.
Internal QoS value. You can specify a number from 0 to 7.
Displays the default mappings.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Quality of Service Commands 105