Set Radio-Profile Auth-Dot1X; Set Radio-Profile Auth-Psk; Set Radio-Profile Auto-Tune Channel-Config - Nortel 2300 Series Reference

Usage You can enter this command on any WSS in the Mobility Domain. The command takes effect only
on that switch.
Examples The following command disables active scan in radio profile radprof3:
WSS# set radio-profile radprof3 active-scan disable
success: change accepted.
See Also
show radio-profile on page 376

set radio-profile auth-dot1x

Deprecated in WSS Software Version 3.0. In 3.0, this parameter is associated with service profiles instead of radio
profiles. See set service-profile auth-dot1x on page 307.

set radio-profile auth-psk

Deprecated in WSS Software Version 3.0. In 3.0, this parameter is associated with service profiles instead of radio
profiles. See set service-profile auth-psk on page 309.

set radio-profile auto-tune channel-config

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the AP radios in a radio profile.
Syntax
set radio-profile name auto-tune channel-config {enable | disable} [no-client]
name
enable
disable
no-client
Defaults Dynamic channel assignment is enabled by default.
Access Enabled.
History
Version 5.0
Usage If you disable RF Auto-Tuning for channels, WSS Software does not dynamically set the channels
when radios are first enabled and also does not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, WSS Software does not allow you to manually change channels.
Radio profile name.
Configures radios to dynamically select their channels when the radios
are started.
Configures radios to use their statically assigned channels, or the default
channels if unassigned, when the radios are started.
Configures radios to change channels regardless of client status. Without
this option, a radio changes the channel only if the radio does not have
any active clients on that channel.
Option no-client added.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 289