Set System Idle-Timeout - Nortel 2300 Series Reference

74 System Services Commands
See Also
show config on page 553
Note.
For Series 2332 access points, be sure the system country code is supported for
the selected access point model.

set system idle-timeout

Specifies the maximum number of seconds a CLI management session with the switch can remain idle before WSS
Software terminates the session.
Syntax
set system idle-timeout seconds
seconds
Defaults 3600 seconds (one hour).
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage This command applies to all types of CLI management sessions: console, Telnet, and SSH. The
timeout change applies to existing sessions only, not to new sessions.
Examples The following command sets the idle timeout to 1800 seconds (one half hour):
WSS# set system idle-timeout 1800
success: change accepted.
See Also
• clear system on page 55
• show system on page 68
NN47250-100 (Version 02.51)
Number of seconds a CLI management session can remain idle before
WSS Software terminates the session. You can specify from 0 to 86400
seconds (one day). If you specify 0, the idle timeout is disabled.
The timeout interval is in 30-second increments. For example, the
interval can be 0, or 30 seconds, or 60 seconds, or 90 seconds, and so on.
If you enter an interval that is not divisible by 30, the CLI rounds up to
the next 30-second increment. For example, if you enter 31, the CLI
rounds up to 60.