Display Event Log; Figure 3-50. Event Log Screen - Nortel BayStack 450-24T Using Manual

Using the BayStack 450 10/100/1000 Series Switch

Display Event Log

This section describes the various functions of the Event Log screen (Figure
3-50).
When the switch is part of a stack configuration, the Event Log screen displays
only the data for the specific unit you are connected to through the Console/
Comm port. However, if you are connected to a stack unit through a TELNET
session, the Event Log screen displays the data for the base unit of that stack
configuration.
Note: This screen does not refresh dynamically to show new entries. To
refresh the screen, press [Ctrl]-P.
Choose Display Event Log (or press e) from the main menu to open the Event Log
screen.
Entry Number: 4
Connection logout, IP address: 38.227.40.8, access mode: no security.
Entry Number: 3
Connection logout, IP address: 38.227.40.8, access mode: no security.
Entry Number: 2
Successful connection from IP address: 38.227.40.8, access mode: no security.
Entry Number: 1
Software downloaded to BayStack Model 450-24T HW:RevA FW:V1.00 SW:V1.0.0.0
Press Ctrl-P to see previous display. Press Ctrl-N to see more entries.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
Figure 3-50. Event Log Screen
3-128
Event Log
sysUpTime: 00:14:36
sysUpTime: 00:13:35
sysUpTime: 00:00:53
sysUpTime: 00:00:00
Reset Count: 2
Reset Count: 2
Reset Count: 2
Reset Count: 1
309978-D Rev 01