No Qos L2-Acl Command; Configuring The Cos-To-Queue Assignments; Qos Queue-Set-Assignment Command; Nortel Ethernet Routing Switch 4500 Series - Nortel 4524GT Configuration

48 Chapter 2 Configuring Quality of Service (QoS) with the CLI
Parameter
drop-action {enable |
disable}
update-dscp <0 - 63>
update-1p <0 - 7>
set-drop-prec {high-drop
| low-drop}
block <block_name>
This command is executed in the Global Configuration command mode.

no qos l2-acl command

The no qos l2-acl command is used to remove a Layer 2 access list.
The syntax for this command is
no qos l2-acl <aclid>
Substitute <aclid> above with the unique identifier of the IP access list
to remove. This value is between 1 and 55000.
This command is executed in the Global Configuration command mode.
Configuring the CoS-to-Queue Assignments
CoS-to-queue assignments can be queried and modified using the following
CLI commands.

qos queue-set-assignment command

The qos queue-set-assignment command associates the 802.1p
priority values with a specific queue within a specific queue set. This
association determines the egress scheduling treatment that traffic with a
specific 802.1p priority value receives.
The Ethernet Routing Switch 4500 supports a fixed queue set size of 4.
The syntax for the qos queue-set-assignment command is
qos queue-set-assignment queue-set
"qos queue-set-assignment parameters" (page 49)
for this command.
Copyright © 2007, Nortel Networks
.
Description
The drop action to use for this access list. Enable
specifies to drop packets and disable specifies to not
drop packets.
The DSCP value to update for this access list.
The 802.1p value to update for this access list.
The drop precedence to configure for this access list.
The block name to associate with the access list.
ATTENTION

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
4 1p <0-7>
outlines the parameters
03.01 Standard
queue <1-4>