Hard disk drive (HDD) and solid state drive (SSD)
7.3.3.2
Removing a 2.5-inch HDD/SSD module
Figure 40: Opening the locking lever
Ê Press the locking lever to open the HDD/SSD module.
Figure 41: Removing the HDD/SSD dummy module
Ê Pull the HDD/SSD module out a few centimeters.
Ê Wait about 30 seconds to allow the HDD to spin down.
I
This is not necessary when removing an SSD.
I
This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the HDD to come to a stop.
Ê Pull the HDD/SSD module completely out of its bay.
7.3.3.3
Concluding steps
Ê No steps needed.
90
Upgrade and Maintenance Manual
GX2460 M1