Acura 1994 Integra Service Manual page 1099

a n d c o m
it with a
a
a
a
a
4t l\
-N r-
\
-l/
Compressor
Clutch Overhaul (cont'dl
Remove the screw from the field coil ground terma-
nal. Remove snap ring A with snap rjng pliers, then
remove the field coil.
NOTE:
. Be careful not to damage the field coil
pressor during removal/installation.
. Once snap ring A is removed, replace
new one.
SNAP RING A
Replace.
FIELD
corL
5.
lnstall in the reverse order of removal, and:
i n s t a l l t h e f i e l d c o i l w i t h t h e w i r e s i d e f a c i n g
down (see above).
clean the pulley and compressor sliding surfaces
with non-petroleum solvent.
check the pulley bearings for excessive play.
make sure the snap rings are in the groove prop-
efly.
apply locking agent to the threads of the center
bolt, and tighten it securelY
make sure that the pulley turns smoothly after
it's reassembled.
1. Remove the relief valve and the O-ring.
NOTE:
. Do not let the compressor oil run out.
.
Make sure there is no foreign matter in the sys-
tem.
RELIEF VALVE
13.2 N.m {1.35 kgtm,9.76lbtftl
2.
lnstall and tighten the relief valve.
Clean the mating surfaces.
Replace the O-ring with a new one at the relief
v a l v e , a n d a p p l y a t h i n c o a t o f r e f r i g e r a n t o a l
(ND-OIL 8: P/N 38899 - PR7 - A01) before install-
ing it.
NOTE:
. To avoid contamination, do not return the oil
t o t h e c o n t a i n e r o n c e d i s p e n s e d , a n d n e v e r
mix it with other refrigerant oils.
. l m m e d i a t e l y a f t e r u s i n g t h e o i l , r e p l a c e t h e
c a p o n t h e c o n t a i n e r , a n d s e a l i t t o a v o i d
moisture absorption.
. D o n o t s p i l l t h e r e f r i g e r a n t o i l o n t h e c a r ; l t
may damage the painu if the refrigerant oil
contacts the paint, wash it off immediately.
Check for leaks, and insert the cap in the top of
the valve.
22-34