Non-Image Area Erase Check (7085 Only); Recall Standard Data (Image Adjustment) - Konica Minolta 7085/FORCE 85 Service Manual

36 ADJUSTMENT
[13] Non-image area erase check (7085
3
only)
When this machine is installed in a place or is moved
to another location, research should be conducted on
the conditions under which the machine is placed.
Preparation: RADF must be opened.
Nothing should be put on the
original glass. The original glass
must be clean and transparent.
Step
1 Enter the 36 mode.
2 [Adjustment mode menu Screen]
Press "
2
3 [Image adjustment mode menu Screen]
7
Press "
4 [Non-image area erase check Screen]
Open the RADF, and press the
key.
5 Confirm that a message indicating that
it operated normally is displayed in the
message display. When a message
indicating it did not operate properly is
displayed, refer to Reference 1 shown
below. Then, perform the non-original
automatic erasure installation research
again.
6 Press the
turn to the Image Adjustment Menu
Screen.
Reference 1:
Here are measures to be taken when the
following error messages are indicated.
<Error message 1>
Adjust for Extreme Brightness. In many cases,
the Non-image-area-erase function will not
operate correctly. Please confirm "adjustment" -
"36 mode" columns of the Service Hand book.
<Countermeasure 1>
If you use the non-original erasure function, or
copy originals that have a dark background using
the non-original erasure method, relatively
infrequently, use the machine in its present
installation environment.
If, however you copy originals that have a dark
background fairly frequently, re-install the
machine in a dark location and facing a direction
such that external light does not get into it, then
carry out the installation survey once again.
MODEL
7075/7085
SERVICE HANDBOOK
Operation
Image adjustment".
Non-image area erase check".
Start
key to re-
PREVIOUS SCREEN
MANUAL REVISED EDITION
<Error message 2>
A datum with potential not to function non-image-
area-erase is found.
Please confirm "adjustment" - "36 mode" columns
of the Service Hand book.
<Countermeasure 2>
If you use the non-original erasure function
relatively infrequently, you can use the machine
in its present installation environment.
If, however you copy originals that have a dark
background fairly frequently, re-install the
machine in a dark location and facing a direction
such that external light does not get into it, then
carry out the installation survey once again. In
this case, if there is a bright light source, such as
a fluorescent light, directly above the machine,
reconsider the installation location and direction,
or take steps to block off the light from the light
source (by using a cover, for example), then carry
out the installation survey once again.
[14] Recall standard data
(Image adjustment)
Restoring image adjustment settings to standard val-
ues (data after process adjustment).
Step
1 Enter the 36 mode.
2 [36 Mode Menu Screen]
Press "
3 [Image adjustment mode menu Screen]
Select "
4 [Recall standard data Screen]
Press the
Various data are restored to standard
values.
5 Press the
turn to the Image Adjustment Menu
Screen.
DATE
1 - 86
Jan. 2002
3
Operation
Image adjustment."
2
7
Recall standard data."
key.
YES
key to re-
PREVIOUS SCREEN
PAGE METHOD
1-86 REPLACEMENT