Table of Contents
Advertisement
OTHER ADJUSTMENT
[9] RADF Skew Adjustment
1.
Tools
• Screwdriver (Phillips)
2.
Adjustment method
Skew
adjustment
screw
Skew
pattern A
Step
1
Set A3 paper into the tray1.
2
Set the adjustment chart on the RADF,
make a copy, and check the skew.
Standard value: within ±0.3%
Feed
direction
Skew pattern A
Perform the following adjustment if the
skew is beyond the standard value.
3
Open the RADF and loosen the four
hinge set screws (two on both the left
and right).
Hinge set
screws
Skew
pattern B
Operation
Skew pattern B
4
Close the RADF, turn the skew
adjustment screws and adjust the skew.
For skew pattern A:
Turn the skew adjustment screw
counterclockwise.
For skew pattern B:
Turn the skew adjustment screw
clockwise.
5
Make a test copy and check the skew.
6
Tighten the four hinge securing screws
(two on both the left and right.)
7
Make adjustment by repeating steps 3
to 6.
1 - 120
Advertisement
Chapters
Table of Contents
