Konica Minolta 7085/FORCE 85 Service Manual page 814

[3] Installation procedure for main body
1. Turn the power to the main body OFF, then unplug
the power cord from the power outlet.
2. Install the main body installation stay on the upper
left side of the main body. (TP screw M4x14: 2
pcs. <FS-110/210 accessory parts>)
Caution:
If the Finisher has been installed on the main body,
remove the main body installation plate (upper)
<FS-110/210 accessory part> from the upper-left
side of the main body, then perform Step 2 ( TP
screw M4x14: 2 pcs.)
3. Remove the installation plate (upper) (1 screw)
from the main body installation plate <FS-110/210
accessory part>, then install it on the main body
installation stay (1 screw).
Installation plate
TP screws M4x14
4. Install the main body installation plate (lower) <FS-
110/210 accessory part> on the lower left side of
the main body. (TP screw M4x6: 2 pcs. <FS-110/
210 accessory parts>)
TP screws M4x6
Main body
installation stay
Main body
installation plate(lower)
5. Connect the two PZ-108 connectors to the
connectors on the rear paper-exit side of the main
body.
PZ-108 connectors
6. Install the PZ-108 + FS-110/210 on the main body.
(1) Lower the paper guide of the PZ-108 (by
pushing up the lever).
(2) Fit the hooks of the main body installation stay
and main body installation plate (lower) into the
upper and lower the notch on the PZ-108, as
illustrated below.
Upper view
PZ-108
Lower view
E-14
Main body connectors
(Small connector)
Lever
Main body