Removing And Reinstalling The Toner Supply Unit - Konica Minolta 7085/FORCE 85 Service Manual

(4) Remove toner supply sleeves 1 and 2.
Caution: Toner supply sleeves 1 and 2 must be
installed observing the correct
orientation shown below.
Toner supply sleeve 2
Correct orientation
Toner supply sleeve 2
(5) Reinstall the above parts following the removal
steps in reverse.
Toner supply sleeve 1
Toner supply sleeve 1
3 - H - 3
[4] Removing and Reinstalling the
Toner Supply Unit
Caution: Be sure the power cord has
been unplugged from the wall
outlet.
a. Procedure
(1) Pull out the toner supply unit completely.
(2) Remove the toner cartridge.
(3) Disconnect the connector (CN473) and remove
the wiring harness from the four wiring harness
clamps.
Caution: Route the wiring harness carefully
when reinstalling the toner supply unit,
because it is a movable component.
Connector (CN473)
Wiring harness
clamps (2)
(4) Loosen the two screws to remove the toner
supply unit.
Screws
(2)
(5) Reinstall the above parts following the removal
steps in reverse.
TONER SUPPLY UNIT