Konica Minolta 7085/FORCE 85 Service Manual page 722

14. Install the Finisher on the main body.
(1) Fit the hooks on the main body installation
plates (upper and lower) into the upper and
lower holes on the Finisher as illustrated be-
low, then lock them by pushing the Finisher to
the back.
Upper view
Lower view
[Caution]
If the gap between Finisher and main body is not
equal from the top through the bottom, adjust it by
the height of the front and rear casters on the pa-
per exit side of the Finisher.
Main body
Loosen
Inclination
adjustment
(2) Fix the Finisher to the main body (front side
only). (TP screw M4x6: 3)
TP screw M4x6
[2] Confirmation of operation (FS-108 only)
1. Turn ON the power switch.
2. Place three originals into the RDH (RADF).
3. Operate printing in sort mode to confirm if the
copier works correctly.
4. Operate printing in staple sort mode to confirm if
copies are stapled correctly.
[3] Setting Change in DIP SW (FS-108B/108BM only)
[Caution]
This setting change should be performed only for
FS-108B/108BM with black paper folding spring
(upper) newly provided for higher performance in
folding mode.
For 7075:
Before starting this procedure, check the main body
ROM C-1 version number which should be 30 or
higher. Using the ROM of Ver. 29 or former version
may cause a trouble in the machine.
For Force 75/DP75:
Before starting this procedure, check the main body
ROM C-1 version number which should be 11 or
higher. Using the ROM of Ver. 10 or former version
may cause a trouble in the machine.
1. Turn ON the main swich while pressing numeric
keypads x and b simultaneously.
2. Touch "[1] Software DIP SW" on the screen.
3. Set the DIP SW 21-7 to ON (1).
4. Turn OFF the main switch.
E-8
Paper folding
spring (upper)