Konica Minolta 7085/FORCE 85 Service Manual page 788

8. Install the Finisher installation stay on the upper-
right side of the Finisher. (TP screw M4x6: 2 pcs.,
TP screw M3x6: 1pc.)
Caution:
• Tighten the screws in sequence from the rear.
• One TP screw 3x6 is installed for positioning of
the TP screw 4x6 in the front.
• The front screw (TP screw M4x6) should be
tightened while pushing down the Finisher
installation stay.
9. Pull the lever of the Finisher installation stay
forward.
Inside of the Finisher
TP screw (M4x6)
TP screw (M3x6)
Lever
(Positioning screw)
10. Install Finisher installation stay A on the lower-
left side of the PU-108. (TP screw M4x6: 2 pcs.)
11. Remove the stay fixed on the upper-left side of
the PU-108 (2 screws), then fix it again in the
lower position.
Finisher installation stay
TP screw (M4x6)
Stay
TP screws (M4x6)
Finisher installation stay A
12. Attach the sponge for FS-106 on the upper-right-
center side of the Finisher.
13. Install the PU-108 on the Finisher.
(1) Connect the two Finisher connectors to the
connectors on the rear paper-exit side of the
PU-108.
Finisher connectors
(2) While tilting the PU-108, put the Finisher
installation stay A on the Finisher stay.
Caution:
Be sure to perform this work by two persons. Be
careful to hurt neither the back nor the waist.
(3) Attach the upper part of the PU-108 to the
Finisher.
Caution:
Be careful so the cord will not be caught between
the Finisher and the PU-108.
(4) Push the lever of the Finisher installation stay
to lock it.
E-6
Sponge
Connectors on PU-108
Lever