Replacing The Heater Lamp (Lower) (L4) - Konica Minolta 7085/FORCE 85 Service Manual

Caution: When installing the fixing heat roller
assembly, be sure to fit the guide pin
in the guide hole on the rear side.
(6) Reinstall the above parts following the removal
steps in reverse.
[8] Replacing the Heater Lamp (Heat
roller) (L4)
Caution: Do not touch the fixing heater
Caution: Install the heater lamp (heat roller)
a. Procedure
(1) Remove the fixing heat roller assembly.
(2) Cut the insulating cable tie to disconnect the
connector (CN462).
(3) Remove one screw to detach the lamp fixing
plate (rear).
Cable tie (for heat insulation)
Screw
(4) Cut two insulating cable ties and remove the
screw securing the cable clamp to remove the
Faston terminal.
(5) Remove one screw to detach the lamp fixing
plate (front).
3 - O - 9
3 - O - 5
lamp (heat roller)(L4) with bare
hands.
(L4) with the maker mark indication
side facing front.
Connector
Lamp fixing plate (rear)
FIXING UNIT