Konica Minolta 7085/FORCE 85 Service Manual page 726

III. Installation procedure
[1] Installation procedure
1. Turn OFF the power switch of the main body, and
unplug the power cord from the power outlet.
2. Visually check the Finisher body, and remove the
lock tape and accessory parts from the Finisher.
3. Remove the connector cover on the left side
cover of the main body. (Truss screw M4x6: 1)
Connector cover
4. Install the main body installation plate (lower) on
the lower left side of main body. (TP screw M4x6: 2)
Main body installation plate (lower)
TP screws M4x6
5. Install the main body installation plate (upper) on
the upper left side of main body. (TP screw
M4x18: 2)
Main body installation plate (upper)
TP screws M4x18
6. Remove the three lock materials that secure
each guide plate inside the Finisher.
7. Remove the two stacker lock materials.(FS-111/
FS-211)Remove the lock tapes. (For FS-211
only)
FS-211 only
E-2
Lock materials
Stacker
lock materials