Konica Minolta 7085/FORCE 85 Service Manual page 727

8. Remove the lock tapes and the lock materials
inside the stacker.
[For FS-111]
Remove the lock tapes and the three lock materials.
Lock materials
[For FS-211]
(1) Remove the two lock materials at the right bot-
tom of the stacker.
(2) Remove the lock tapes and the two lock mate-
rials at the left bottom of the stacker.
Lock materials
Left bottom
Lock materials
Lock tapes
9. Install the paper exit up-down tray on the up-
down portion (paper exit side) of the Finisher.
(Truss screw M4x6: 2)
[Caution]
When installing paper exit up-down tray, fit the four
auxiliary fittings to the guide holes of the paper exit
up-down tray before fixing screws.Set the software
DIP switch following the procedure below.
10. Install the paper exit tray (lower) on the lower up-
down portion (paper exit side) of the Finisher.
[Caution]
The paper exit tray (lower) is attached to FS-211
only.
11. Install the paper exit tray /1 on the secondary
exit portion, then fix it with screws. (SEMS II
M3x6: 2)
SEMS II M3x6
E-3
Paper exit
up-down tray
Truss screws M4x6
Paper exit tray (lower)
Paper exit tray /1