Konica Minolta 7085/FORCE 85 Service Manual page 682

1. Place the wooden spacers under the Adjuster feet.
Then extend the Adjuster feet enough to remove
the cushions with the spanner attached to the
accessory box (Fig. 05).
Fig. 05
Spanner
Adjuster foot
2. Remove the cushions. Then wind up the Adjuster
feet again to let the machine descend onto the
pallet. Be sure to work on the above steps 1 and 2
in succession, respectively for the right side and
left side of the machine.
3. Fix the veneer with 2 nails at the right end face of
the pallet, setting its beveled portion upward (Fig.
06).
Fig. 06
Corrugated fiberboard
4. Set the 4 cushions and 4 wooden spacers removed
from the machine, below the veneer as illustrated
below. (Fig. 07).
Fig. 07
Corrugated
fiberboard
Cushions
Wooden spacer
Nail: 2pcs
Veneer
(A) (D) or (E) 2 Spacers
Veneer
(A)
2 Spacers
(D) or (E)
Cushion rear (A)
Cushion front (D, E)
Cushion left (B, C)
5. Bring down the machine carefully on the floor by
two persons (Fig. 08).
Fig. 08
Caution:
Confirm that the Adjuster feet are fully wound up
before moving the machine.
IV. Accessories Packed Together with the
Main Body
1. Wooden spacers
2. Spanner
3. Operation manual holder
4. Ventilation duct
5. Developer (For U.S.A only)
6. Cotton swabs
7. Setup report (For U.S.A only)
8. Unpacking and installation manual
9. Operation manual
10. Operation sheet (French) / (For Europe only)
11. Operation sheet (German) / (For Europe only)
12. Operation sheet (Italian) / (For Europe only)
13. Nails
14. Veneer
15. Cleaning instruction label
16. Working table
17. Truss head screws M4 x 14 : 2pcs
18. Bind screws M3 x 6 : 2pcs.
19. Cap
E-2