Konica Minolta 7085/FORCE 85 Service Manual page 728

12. Connect the two connectors of the Finisher to
the two connectors on the rear left side cover of
the main body.
13. Install the Finisher on the main body.
(1) Fit the hooks on the main body installation
plates (upper and lower) into the upper and
lower holes on the Finisher as illustrated
below, then lock them by pushing the Finisher
to the back.
Upper view
Lower view
[Caution]
If the gap between Finisher and main body is not
equal from the top through the bottom, adjust it by
the height of the front and rear casters on the
paper exit side of the Finisher.(shown:FS-211)
Main body
Loosen
Inclination
(2) Fix the Finisher to the main body. (front side
only)(TP screw M4x6: 3)
TP screws M4x6
[2] Confirmation of operation (FS-111 only)
1. Turn ON the power switch.
2. Place three originals into the RADF.
3. Operate printing in sort mode to confirm if the
copier works correctly.
4. Operate printing in staple sort mode to confirm if
copies are stapled correctly.
E-4
adjustment